Yes, I manufacture hand made high quality wheels with our components. 

I spend hours to build with highest diligence and urge to ultimate perfection your dream wheel. 

Our goal is the perfect wheel. 

For the rear wheel I use without exception Rohloff Speedhub internal gear hubs. These are - in our opinion and experience - simply the best bicycle gears. 
Read this to know more about the Rohloff Speedhub. 
In the front we use the solid Schmidt hub dynamos, as SONs and SONdeluxs are as best for the front as Rohloffs are for the rear. 

In our service station we use only the best tools. 

Perfect results can only be achieved by using plenty of time, patience, experience and high quality tools. 

I work with high precision tools: 

• the truing stand, the tensiometer and the pre press device come from Centrimaster 
• the nipple driver, the nipple clamping screwdriver and the nipple wrench come from Sapim 
• the hexagonal nipple key is from Wiha 
• and from P&K Lie is the nipple wrench, which is used for the fine- and final-alignment 

At the end we have a high-end wheel, which should be so solid build, that the spoke tensions are homogeneous, the radial and axial run-out best possible and the afterwards elsewhere common centering is not necessary anymore.