Takaisin yleiskatsaukseen

SON Edelux 2 DC 6-75 V

Zoom

SON Edelux 2 DC 6-75 V

Malli #: son_edelux_2_dc_6_75v

Ei arvosteluja

Valitse muuttuja

201,95 € *

Tuotekuvat

Kuvaus

Power supply for electrically assisted bicycles is not standardized, therefor two different lights for varying drive systems are offered:

Edelux II DC 6 Volt

for voltages from 5.5 to 8 volts DC
power input results in approx. 600 mA
luminance approx. 80 lux
suitable for systems with 6-V-DC-output (e.g. Bosch Active and Performance or Shimano Steps)
not suitable for systems with low current limitation (Bosch Classic)
the lights are turned on using the display and so there is no need for a light switch nor an outlet for a rear light

There are two options for connecting the light to the drive unit:

with a 140 cm long coaxial cable
with a cable from the drive manufacturer with two spade connectors 2.8 x 0.5 mm or with one spade connector plus a ring terminal

Edelux II DC 6 to 75 Volts

for voltages from 6.0 up to 75 volts
out of 5.8 – 6.4 Volts results a power input of 2 – 2,5 Watt (60 to 70 lux)
out of 6.5 – 75 Volts results a power input of approx. 3 Watt (90 lux)
for 6-volt-supply with low current limitation (Bosch Classic) and direct light supply with battery voltage
On-Off switch (switching ring can be by a covering ring replaced)
rear light output 6 Volt DC (for regular dynamo rear lights)

Attention:
The installation must be carried out by qualified personnel. The specifications of the drive unit must be followed strictly. Mistakes can result in damages on the e-bike electronics. Any operations on systems with more than 60 Volts must be conducted by an electrically qualified person.